Sio Nct6112D - DFI SO630 User Manual

Advanced
X

SIO NCT6112D

Configure Super I/O settings in this submenu. Scroll by moving the cursor up or down to reveal
more options.
InsydeH2O Setup Utility
Advanced
COM1 <Enable>
Base I/O Address <228>
Interrupt <IRQ4>
Mode <RS232>
COM2 <Enable>
Base I/O Address <338>
Interrupt <IRQ3>
WDT <Enable>
WDI Count Mode <Second>
Counter [38]
Case Open Status Close
Case Open Alert <Enable>
Clean Case Open Status
►Hardware Monitor
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
COM1
Enables or disables the serial ports (COM). The following bracketed fields will only appear
when the port is enabled.
COM2
Enables or disables the serial ports (COM). The following bracketed fields will only appear
when the port is enabled.
WDT
Enable or disable the Watchdog Timer (WDT) function. A counter will appear if you select to en-
able WDT. Input any value between 1 to 255 seconds.
▼ WDT = [Enable]
Counter
Set the timeout value of the WDT — 1-255 seconds.
Case Open Alert
Enable or disable case open alert.
Clean Case Open Status
Clean current case open status including alert.
User's Manual | SO630
Rev. 5.0
Configure Serial port using op-
tions: [Disable] No Configura-
tion [Enable] User Configuration
[Auto] EFI/OS chooses configu-
ration
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
Chapter 3
BIOS SETTINGS
28