Table of Contents
Advertisement
Advanced
X
SIO NCT6126D
Configure Super I/O settings in this submenu. Scroll by moving the cursor up or down to reveal
more options.
InsydeH2O Setup Utility
Advanced
COM Port 1
<Enable>
Base I/O Address
<3F8>
Interrupt
<IRQ4>
RS485 Auto Flow
<Disable>
COM Port 2
<Enable>
Base I/O Address
<2F8>
Interrupt
<IRQ3>
RS485 Auto Flow
<Disable>
COM Port 3
<Enable>
Base I/O Address
<3E8>
Interrupt
<IRQ4>
COM Port 4
<Enable>
Base I/O Address
<2E8>
Interrupt
<IRQ3>
WDT
<Disable>
Case Open Status
CLOSE
Case Open Alert
<Disable>
Clean Case Open Status
►PC Health Status
F1
Help
↑ /↓
Select Item
Esc
Exit
←/→
Select Item
COM Port 1/2
Enables or disables the serial ports (COM). The following bracketed fields will only appear
when the port is enabled.
COM Port 3/4
Enables or disables the serial ports (COM). The following bracketed fields will only appear
when the port is enabled.
WDT
Enable or disable the Watchdog Timer (WDT) function. A counter will appear if you select to en-
able WDT. Input any value between 1 to 255 seconds.
▼ WDT = [Enable]
Case Open Alert
Enable or disable case open alert.
Clean Case Open Status
Clean current case open status including alert.
User's Manual | CMS310
Rev. 5.0
Configure Serial port using op-
tions:
[Disable] No Configuration
[Enable] User Configuration
[Auto] EFI/OS chooses configu-
ration
F5/F6
Change Values
F9
Setup Defaults
Enter
Select
SubMenu
F10
Save and Exit
X
Chapter 3
BIOS SETTINGS
42
Advertisement
Table of Contents
