Debug Configuration; Uefi Device Manager - DFI SO630 User Manual

Advanced
X

Debug Configuration

This section configures Debug setting.
InsydeH2O Setup Utility
Advanced
Debug Configuration
Dynamic EFI DEBUG <On>
This debug function is only used for J1
internal UART EFI debug baud rate [115200]
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
Dynamic EFI DEBUG
This field is used to turn on or off the function to output debug message from COM port. When
this field is set to "On", the following EFI debug configurations will be displayed.
This debug function is only used for J1 internal UART EFI debug baud rate
Enter the baud rate to output EFI debug message. The default is 115200.
User's Manual | SO630
Rev. 5.0
Enable it to output debug mes-
sage from COM port.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
Advanced
X

UEFI Device Manager

Configure UEFI device with option ROM, such as LAN card, etc.
InsydeH2O Setup Utility
Advanced
UEFI Device Manager
Exit BIOS Setup Utility and launch Device Manager !!
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
Press "Enter" and "OK" to enter UEFI Device Manager setup page. More device settings can be
configured in the UEFI Device Manager, including LAN, Network Stacks, and etc.
Note:
Network Device will not be configurable in Device Manager if "Network Stack" is
disabled in the "Boot" menu.
Chapter 3
BIOS SETTINGS
UEFI Device Manager Setting
[OK]
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
Rev. 5.0
27