Raven SmarTrax Installation Manual page 25

Base-End of Sensor Installed on the Machine
FIGURE 4.
Install three 0.406" ID x 0.812" OD x 0.065" flat washers (P/N 313-2300-014) on the stud mount of the linear
4.
sensor to offset the sensor from the base mounting bracket.
Secure the base-end of the WAS (P/N 063-0181-017) to the base mounting bracket using one washer (P/N
5.
313-2300-014) and one M10 x 1.5 nylon insert lock nut (P/N 312-4000-208).
Note:
The rod-end of the sensor should point toward the left side of the machine.
M10 Bolt Inserted into Rod Mounting Bracket
FIGURE 5.
Insert the M10 x 1.5 metric hex bolt (P/N 311-0070-033) into the rod mounting bracket (P/N 107-0172-030).
6.
Remove the nuts and clamp from the 1-1/2" muffler clamp (P/N 435-3003-030).
7.
Manual No. 016-5034-005
Wheel Angle Sensor Installation
21