Raven SmarTrax Installation Manual page 27

Spacers Installed on Rod Mounting Bracket
FIGURE 8.
Install two 3/8" ID x 3/4" OD x 3/4" long spacers (P/N 107-0172-037) on the M10 bolt.
11.
Rod-End of Sensor Installed on Machine
FIGURE 9.
Install the rod-end of the WAS to the end of the installed M10 bolt using one M10 x 1.5 nylon insert lock nut
12.
(P/N 312-4000-208).
Important:
Verify that the WAS cannot be overextended or compressed when the wheels are turned to their
extremes. Also verify that the sensor moves freely and is not being damaged within its range of motion.
Route the sensor cable toward rod-end of the sensor and to the back of the tractor, following along the left
13.
steering cylinder hydraulic hoses.
Secure the cable to the sensor body and left steering cylinder hoses using plastic cable ties.
14.
Manual No. 016-5034-005
Wheel Angle Sensor Installation
23