Chapter 3
Install Fittings in the SmarTrax Valve
Before mounting the SmarTrax valve (P/N 334-0003-088) on the machine, install the proper fittings in the
valve. This prepares the valve for installation and simplifies the hose connection process later in the procedure.
Fittings Installed in the SmarTrax Valve
FIGURE 1.
Fitting - -4 SAE O-Ring (M) Plug
Fitting - -4 ORFS (M) to -6 SAE O-Ring (M) Straight Adapter
Fitting - -6 ORFS (M) to -8 SAE O-Ring (M) Straight Adapter
Fitting - -6 ORFS (M) to -10 SAE O-Ring (M) Straight Adapter
Cartridge - -08 Ball Shuttle Hydraulic
Refer to the table and figure above to install the fittings in the appropriate ports of the SmarTrax valve.
1.
Remove the existing cartridge from Port EP1 of the SmarTrax valve and replace it with the -08 ball shuttle
2.
hydraulic cartridge (P/N 334-0002-109).
12
The appearance of the SmarTrax hydraulic
valve may vary slightly from the images
contained in this manual. However, the fittings,
hose connections, and cable connections
remain the same.
Fitting
John Deere 8X00/8X10 Series SmarTrax™ Installation Manual
NOTICE
Part Number
333-0012-051
333-0012-195
333-0012-199
333-0012-233
334-0002-109
Port
PS
LS STEER
P, T
A, B
EP1