Chapter 4
Connect the DGPS OUT connector to the DGPS connector on the console cable.
5.
Connect the CAN connector on the node harness to the machine's existing CAN connection.
6.
Connect the remaining 4-pin connector on the node harness to the machine's mating 4-pin power
7.
connection.
Node Harness Connected to Valve Harness
FIGURE 6.
Connect the 12-pin connector of the node harness into the mating connector of the valve harness.
8.
Install the Valve Harness
Valve Harness Connected to Bulkhead Plugs
FIGURE 7.
Connect the 12-pin connector of the valve harness to the connector located at the bulkhead plugs in the
1.
right-rear corner of the cab.
20
Apache ASXX20 Series, Model Year 2012 SmarTrax™ Installation Manual