Raven SmarTrax Installation Manual page 49

C
Cab Component Installation
Connecting SmarTrax to an Existing Chassis Cable 37
Connecting the Factory-Installed Enable Switch (If
Applicable) 31
Installing the Chassis Cable - SmarTrax-Only
Systems 37
Installing the Foot Switch 31
Installing the Master Switch 32
Installing the SmarTrax Node 27
Node Mounting Locations 30
Preparing the Cab for Installation - Models 250,
280, and 305 27
Preparing the Cab for Installation - Models 260,
290, and 310 29
Installing the Valve Harness 33
System Diagrams 38
H
Hydraulic Installation
Hydraulic Diagram 18
Installing Fittings in the SmarTrax Valve 12
Installing the Left and Right Steering Hoses 14
Installing the Load Sense Hoses 17
Installing the Pressure and Tank Hoses 15
Mounting the SmarTrax Valve 13
I
Important Safety Information
Electrical Safety 2
Hydraulic Safety 2
Introduction
Kit Contents 6
Preparing for Installation 3
Point of Reference 4
Recommendations 4
Updates 4
K
Kit Contents
6
S
Startup Procedures
Calibrating the SmarTrax System 44
Verifying the SmarTrax System Installation 43
W
Wheel Angle Sensor Installation
Assembling the WAS 19
Mounting the WAS 20
Models 250, 280, and 305 20
Models 260, 390, and 310 23
P/N 016-5031-002 Rev. C
Index
45