Cable Secured
FIGURE 9.
Route the WAS cable along the body of the sensor (toward the rod-end) and to the radiator and secure it
12.
with plastic cable ties.
Important:
Allow enough slack in the cable to allow the front axle to move laterally. Secure the cable away from
moving parts and heat sources using plastic cable ties.
Models 260, 290, and 310
Bolt to be Removed
FIGURE 10.
Remove the top bolt on the left side of the front axle differential housing.
1.
P/N 016-5031-002 Rev. C
Wheel Angle Sensor Installation
Secured with
Cable Ties on
Sensor Body
23