Rod Mounting Bracket Installed
FIGURE 13.
Remove the nuts and clamp from the 1-7/8" muffler clamp (P/N 435-3003-055) and install the U-bolt around
6.
the right side of the tie rod with the U-bolt pointing toward the hydraulic cylinder.
Install the clamp as shown in Figure 6 above using the 5/16" nuts that came with the clamp.
7.
Install the rod mounting bracket and M10 bolt on the muffler clamp using two 5/16"-18 nylon insert lock nuts
8.
(P/N 312-4000-059).
Note:
The M10 bolt should be pointing toward the hydraulic cylinder.
Rod-End of Sensor Installed on Machine
FIGURE 14.
Install the rod-end of the WAS on the end of the installed M10 bolt.
9.
Install the 0.406" ID x 0.75" OD x 0.75" long steel spacer (P/N 107-0172-037) on the end of the M10 bolt.
10.
Install a M10 nylon insert lock nut (P/N 312-4000-208) on the end of the bolt.
11.
P/N 016-5031-002 Rev. C
Wheel Angle Sensor Installation
25