Transport; Storing Pulverizer With Drawbar Removed; Drawbar Attachment When Pulverizer Is Stored - Landoll Brillion X108 Operator's Manual

Transport (With Automatic Lock Models)
Fold the wings for transport. In transport relieve the hydraulic pressure until the cylinder transport lock is tight
against pin in the lift arm. There should be no need to do anything with pulverizer when going from field to
transport or transport to field.

Storing Pulverizer With Drawbar Removed

Start with pulverizer in field position. It may be necessary to move some additional drawbar shims to the bot-
tom side of the drawbar braces. Install the storage cylinder lockout which is 5-1/4" long that is attached to a
hydraulic hose on the center cylinder. Fold the wings with the cylinder transport lock up, with 1" nut on center
cylinder anchor bolt tightened. Position pulverizer with tractor where it will be stored. Relieve the hydraulic
pressure until the storage cylinder lockout is tight against the end of the cylinder barrel. Remove hydraulic
line brackets from the drawbar next. It is not necessary to break any hydraulic lines. Rest the hydraulic lines
on the center frame. The drawbar braces and drawbar can now be removed.

Drawbar Attachment When Pulverizer Is Stored

Attach the drawbar and drawbar braces. Next assemble hydraulic lines to the drawbar. Refer to setup in-
structions. Hitch tractor to drawbar. Raise center section and remove pulverizer from storage. Next unfold
wings completely then raise center section completely. Remove storage cylinder lockout and loosen 1" nut on
center cylinder anchor bolt slightly to allow free movement of transport lock.
Figure 2
683rev501 6J862
Page 7