Landoll Brillion X108 Operator's Manual page 29

1. Install each Light Bracket to the rear frame tube, approximately 25" from the center of the
frame, making sure there is sufficient clearance between the bracket and raised tire. Secure
with 3/8 Bolt and Nut. Attach the Tail Light Mounts to the ends of the rear frame and secure
with 5/8-11 U-Bolts and Nuts, ensure U-Bolts are not interfering with raised wheel arm
tube. See page 17B.
2. Install the Light Module under the Module Bracket using two 1/4-20 X 1-1/2" Screws and
Locknuts. See page 17B. Attach the Module Bracket to the front frame tube left of center, using
two 3/8-16 U-Bolts and Nuts. See pages 17B and 17C.
3. Attach the 7 pin harness to the Light Module. Route the harness along the frame and drawbar
with the hydraulic hoses. See page 17C.
4. Layout the LED Lamp Harness. Note that the cords are marked "Left" and "Right".
Attach the harness to the Light Module.
5. Route the left 3 plug cord along the left side of the frame center tube, across the rear frame
tube, then under and through the Left Tail Light Mount.
6. Route the right 3 plug cord along the right side of the front frame tube and along the inside
of the inner frame tube, then under and through the Right Tail Light Mount.
7. Route the remaining left and right 2 plug cords along the left and right front frame tube. Route a
2 plug cord end into the bottom of each Lamp Bracket until the end sticks out the top. See page
17C.
8. Plug a 2 plug harness end into each Amber LED Lamp. Attach Amber LED Lamp to the light
bracket with 1/4-20 X 1-1/2 Screws and Locknuts. Attach the left Lamp Bracket to the back of
the front frame tube and the right Lamp Bracket to the front of the front frame tube using 1/2-13
U-Bolts, Flat Washers and Locknuts. See page 17C.
9. Plug a 3 plug harness end into each Red LED Lamp. With the lens facing rearward, install a Red
LED Lamp onto each Tail Light Mount using 1/4-20 X 1-1/2 Screws and Locknuts. See page
17C.
10. Secure both harnesses with tie straps, making sure to leave enough slack, where the drawbar
meets the frame, to allow the machine to raise and lower. Secure LED lamp harness molded
union to module bracket using Tie Straps. Bundle and secure any excess cord with tie straps.
See page 17C.
11. Raise, lower, fold and unfold machine to check for proper clearance, adjust accordingly.
NOTE: Connectors marked with Green Tape is Right Side and Yellow Tape is Left Side.
683rev1113
LED Lamp and Harness Installation
17D 6J862