Replacing the solid-state drive
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Procedure
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Insert the solid-state drive at a 45-degree angle into the system board.
3. Press the other end of the solid-state drive down and replace the screw that secure the solid-state drive to the system board.
1. solid-state drive
3. tab
5. solid-state drive slot
Post-requisites
1. Replace the
graphics
card.
2. Follow the procedure from step 10 to step 11 in
3. Replace the
left-side
cover.
58
computer. After working inside your computer, follow the instructions in
"Replacing the power-supply
2. notch
4. screw
6. system board
unit".
After working
www.dell.com/