Solid-State Drive; Removing The Solid-State Drive - Alienware AURORA R11 Service Manual

2. Align the notch on the memory module with the tab on the memory-module slot.
3. Insert the memory module into the memory-module slot and press the memory module down until it snaps into position and the
securing clips lock in place.
CAUTION: To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
NOTE: Repeat step 1 to step 3 to replace any other memory modules installed in your computer.
4. Rotate the power-supply unit cage towards the chassis.
5. Slide the power-supply unit cage release latches towards the locked position.
NOTE: Use slots XMM1 and XMM2 if you need to use two memory modules. For more information, see
components.
The following table lists the available memory configuration matrix:
Table 2. Memory configuration matrix
Configuration
8 GB DDR4
16 GB DDR4
32 GB DDR4
64 GB DDR4
16 GB XMP
32 GB XMP
64 GB XMP
Next steps
1. Remove the left-side cover.
2. Follow the procedure in

Solid-state drive

Removing the solid-state drive

Prerequisites
1. Follow the procedure in
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
NOTE: To avoid data loss, do not remove the drive while the computer is in sleep or on state.
2. Remove the left-side cover.
3. Remove the single-graphics card
About this task
The following images indicate the location of the solid-state drive and provides a visual representation of the removal procedure.
46
XMM1
8 GB
8 GB
16 GB
16 GB
8 GB
16 GB
16 GB
After working inside your
Before working inside your
or dual-graphics
Slot
XMM2
8 GB
16 GB
16 GB
8 GB
16 GB
16 GB
computer.
computer.
card, as applicable.
XMM3
16 GB
16 GB
system-board
XMM4
16 GB
16 GB