Replacing The Memory Modules; Procedure - Alienware Aurora R6 Service Manual

Replacing the memory modules

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1. Ensure that the securing clips are extended away from the memory-module slot.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Insert the memory module into the memory-module slot and press the memory module down until it snaps into position and the
securing clips lock in place.
1. memory module
3. memory-module slot
NOTE: Use slots XMM1 and XMM2 if you need to use two memory modules. For more information, see
components.
The following table lists the available memory configuration matrix:
Table 2. Memory configuration matrix
Configuration
8 GB DDR4
12 GB DDR4
16 GB DDR4
16 GB DDR4
computer. After working inside your computer, follow the instructions in
DIMM1
4 GB
4 GB
8 GB
16 GB
2. securing clips (2)
4. system board
Slot
DIMM2
4 GB
8 GB
8 GB
DIMM3
After working
www.dell.com/
System-board
DIMM4
55