Replacing the solid-state drive
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
instructions in
After Working Inside Your
home page at dell.com/regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the hard drive.
Procedure
1
Slide the solid-state drive into the slot on the solid-state drive assembly.
2
Replace the screw that secures the solid-state drive to the solid-state drive assembly.
3
Align the screw holes on the solid-state drive assembly with the screw holes on the computer base.
4
Replace the screws that secure the solid-state drive assembly to the computer base.
5
Connect the solid-state drive cable to the system board.
6
Align the screw holes on the solid-state drive bracket with the screw holes on the solid-state drive assembly.
7
Replace the screws that secure the solid-state drive bracket to the solid-state drive assembly.
Post-requisites
Replace the
base
panel.
18
Before Working Inside Your
Computer. For more safety best practices, see the Regulatory Compliance
Computer. After working inside your computer, follow the