Table of Contents
Advertisement
speakerphone
Place a call using a
headset
Redial
Dial from a call log
Place a call while
Another call is active
Tips
• You can dial on-hook, without a dial tone (pre-dial). To pre-dial, enter a number, and then go off-hook by lifting the handset or
pressing
, Headset or Speaker button.
• If you make a mistake while dialing, press C button to erase digits.
4.2 Answering a Call
You can answer a call by simply lifting the handset, or you can use other options if they are available on SayHi IP Phone.
If you want to...
Then...
Answer
with
a
1) Your phone rings.
handset
2) Line button of the ringing line is
Answer
with
the
speakerphone
(Non-headset mode)
Answer
with
a
headset
Switch
from
a
1) Another Line button is Red
connected
Call
to
2) Press the flashing
answer a ringing
call
1) Press MENU or OK button > "Function setting" > "Auto answer".
Auto-answer
2) Select "Enable".
3) Your phone answers incoming calls automatically after a few rings
4.3 Ending a Call
To end a call, hang up. Here are some more details.
If you want to...
Hang
up
while
Escene Communication
or Programmable buttons
Put on your headset and active
Headset button, and then do as using
speakerphone
Press REDIAL button to dial the last number
-or press Navigation Button-Right > "Dialed number", select a number, and
press
1) Press MENU or OK button
"Received calls" and "Dialed numbers",
- or press Navigation button (in Standby interface) > select "Missed calls"
(down), "Received calls" (left) and "Dialed numbers" (right)).
2) Then press
1) Press Hold button or soft key
2) Press again the line one or the other line, you can enter another number.
3) Press '#' button (default).
-or press
to send the number.
Red
and flashing, Light strip is
Red
and flashing；
Line button to answer (at this time, the original call will be hold.)
Then...
using
the
Return the handset to its cradle,
4) Press '#' button（default),
-or press
-or wait 5s (default), then it sends the
number automatically.
"Call history", you can select "Missed calls",
>
button.
;
Pick up the handset
Press Speaker button
-or press the flashing
-or press
Put on headset, press Headset button so that
the status light is Red
using speakerphone
and flashing, Light strip is Red
;
Line button,
, and then do as
and flashing.
.
www.escene.cn/en/
12
Advertisement
Table of Contents
