Axis 2N Access Unit Configuration Manual page 60

The tamper switch equipped models help detect opening of the device cover and
signal this event as
read out via HTTP API (refer to the
If the function is enabled, all the switches get blocked for 30 minutes whenever the
tamper is activated. Blocking is active even after the device restart. Each port can be
controlled via Automation
the configuration factory values to unblock the switches.
Assigned input – select the logical input to which the tamper switch is to be
connected. TamperSwitchActivated
Enable automatic switch blocking – block the switches by tamper activation for
30 minutes.
Switch blocking state – display and make switch blocking settings.
Note
From PCB version 599v2 up, each of the models is equipped with an
optical tamper switch.
From PCB version 599v2 up, the assigned input is indicated by a module
pictogram backlight. In lower PCB versions, it is indicated by the LED
light on the right-hand module side.
Note
Menu Digital Inputs is available for models:
®
2N IP Verso
®
2N IP Vario
2N Access Unit
2N TELEKOMUNIKACE a.s., www.2n.cz
TamperSwitchActivated
HTTP API
. Press the UNBLOCK
®
and 2N IP Force
. The events are written into a log and
manual).
button, disable the function or reset
signals the tamper switch activation.
if an internal card reader is installed
60/128