Axis 2N Access Unit Configuration Manual page 102

MD5 Authentication Enabled – enable authentication of network devices via the
802.1x EAP-MD5 protocol. Do not enable this function if your LAN does not
support 802.1x. If you do so, the
Password – enter the access password for EAP-MD5 authentication.
TLS Authentication Enabled – enable authentication of network devices via the
802.1x EAP-TLS protocol. Do not enable this function if your LAN does not
support 802.1x. If you do so, the
Trusted Certificate – specify the set of trusted certificates for verification of the
RADIUS server public certificate validity. Choose one of three sets of certificates;
refer to the Certificates subsection. If no trusted certificate is included, the
RADIUS public certificate is not verified.
User Certificate – specify the user certificate and private key for verification of
the 2N Access Unit
network element port in the LAN. Choose one of three sets of user certificates
and private keys; refer to the Certificates subsection.
Trace
On the Trace tab, you can launch capturing of incoming and outgoing packets on the
2N Access Unit network interface. The captured packets are stored in a 4 MB buffer.
When the buffer fills up, the oldest packets are overwritten automatically. We
recommend you to lower the video stream transmission rate below 512 kbps while
capturing. Press
2N TELEKOMUNIKACE a.s., www.2n.cz
2N Access Unit
2N Access Unit
authorisation to communicate via the 802.1x-secured
to start, to stop and
will become inaccessible.
will become inaccessible.
to download the packet capture file.
102/128