Scope Of Delivery And Accessories; Charging The Prosthesis Battery; Connecting The Power Supply And Battery Charger - Otto Bock Kenevo 3C60 Instructions For Use Manual

Scope of Delivery and Accessories

5 Scope of Delivery and Accessories
Scope of Delivery
• 1 pc. Kenevo 3C60=ST (with threaded connector) or
• 1 pc. Kenevo 3C60 (with pyramid connector)
• 1 pc. AXON tube adapter 2R17
• 1 pc. 757L16* power supply
• 1 pc. 4E70* inductive charger
• 1 pc. 647G947 instructions for use (qualified personnel)
• 1 pc. 646D700, 646D700=1 instructions for use (user)
• 1 pc. cosmetic case for battery charger and power supply
• 1 pc. 647F507 prosthesis passport
• 1 pc. card holder for prosthesis passport
Accessories
The following components are not included in the scope of delivery and may be ordered separately:
• 3S26 cosmetic foam cover
• Kenevo Protector 4X840
• "K-Soft 4X445=*" adjustment software

6 Charging the prosthesis battery

The following points must be observed when charging the battery:
• The capacity of a fully charged battery is sufficient for one full day.
• We recommend charging the product overnight when used by the patient on a daily basis.
• When used daily, the complete charging unit (power supply – battery charger) may remain plugged into the
wall socket.
• The battery should be charged for at least 3 hours prior to initial use.
• Note the permissible temperature range for charging the battery (see Page 33).
• Use the 757L16* power supply and 4E70* battery charger to charge the battery.
• The tube adapter must be connected before disconnecting the battery charger, otherwise an error message
will result (see Page 32).

6.1 Connecting the power supply and battery charger

1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see fig. 1).
2) Connect the round, three-pin plug of the power supply to the receptacle on the inductive charger so that the
plug locks into place. (see fig. 2)
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the battery charger.
3) Plug the power supply unit into the outlet (see fig. 3).
→ The green LED on the back of the power supply lights up.
→ The yellow LED on the inductive charger lights up briefly to indicate the correct connection to the power
supply.
→ If the green LED on the power supply does not light up and the yellow LED on the inductive charger does not
light up briefly while connecting the cable, there is an error (see Page 32).
16 | Ottobock
2 3
Kenevo 3C60/3C60=ST