Symbols On The Battery Charger; Operating States/Error Signals; Signals For Operating States - Otto Bock Kenevo 3C60 Instructions For Use Manual

Lot number
Legal manufacturer
Compliance with the requirements according to "FCC Part 15" (USA)
Non-ionising radiation
Compliance with the requirements according to the "Radiocommunications Act" (AUS)
Protection against penetration of solid foreign objects with a diameter greater than 12.5 mm, pro­
tection against water dripping diagonally up to 15°.
Caution, hot surface

13.1.2 Symbols on the battery charger

In some jurisdictions it is not permissible to dispose of these products with unsorted household
waste. Disposal that is not in accordance with the regulations of your country may have a detri­
mental impact on health and the environment. Please observe the instructions of your national
authority pertaining to return and collection.
Declaration of conformity according to the applicable European directives
Lot number
Protect from moisture
Protection against penetration of solid foreign objects with a diameter greater than 12.5 mm, no
protection against water

13.2 Operating states/error signals

The prosthesis indicates operating states and error messages through beeps and vibration signals.

13.2.1 Signals for operating states

Battery charger connected/disconnected
Beep signal
1 x short
1 x short
Kenevo 3C60/3C60=ST
Vibration signal
None
3 x short
1x before beep signal
Event
Battery charger connected or
battery charger already disconnected prior to start of char­
ging mode
Charging mode started (3 sec. after connecting the bat­
tery charger)
Battery charger disconnected after start of charging mode
Appendices
Ottobock | 31