Connect Battery Charger To The Product; Display Of The Current Charge Level - Otto Bock Kenevo 3C60 Instructions For Use Manual

6.2 Connect battery charger to the product

INFORMATION
Do not move the knee joint while it conducts the self-test immediately after disconnecting the charger. Otherwise,
an error may occur; if this happens, the problem can be corrected by reconnecting and then disconnecting the
charger.
INFORMATION
To make the operating time of the prosthesis as long as possible, the charger should not be removed until imme­
diately before the prosthesis is used.
Indication of the charging process:
Charger
Battery is charging.
The on time of the LED indicates the current battery charge level.
The on time of the LED gets longer as the charge level increases. It only flashes briefly at the start
of the charging process and stays on continuously at the end of the charging process.
Battery is fully charged, or the temperature fell above/below the permissible range during charging.
Check current charge level (see Page 17).

6.3 Display of the current charge level

Beep signal
5x short
4x short
3x short
2x short
1x short
1x short
Kenevo 3C60/3C60=ST
1) Connect the inductive charger to the receiver of the charging unit on the rear of
the product. The charger is held in place by a magnet.
→ The correct connection of the battery charger to the product is indicated by
feedback (see Page 33).
2) The charging process starts.
→ Once the product battery is fully charged, the LED on the battery charger
lights up green.
3) After the charging process is complete, hold the product still and remove the
inductive charger from the receiver.
→ A self-test is performed. The joint is operational only after corresponding
feedback (see Page 33).
1) Turn the prosthesis 180° (the sole of the foot has to face up).
2) Hold still for 2 seconds and wait for beeps.
Vibration signal
3x long
5x long
Charging the prosthesis battery
Battery charge level
more than 80%
66% to 80%
51% to 65%
36% to 50%
20% to 35%
less than 20%
Ottobock | 17