Safety Warnings - Ier Automatic Systems BL52 Operating Manual

1.

SAFETY WARNINGS

Y
OUR RISING BARRIER TYPE
. A
COMPONENTS
ENDANGER YOUR SAFETY
(4:1)
LOCATED BEHIND THE SIDE DOOR
WHICH MIGHT BE UNDER POWER OR COULD BE SET IN MOTION
IF YOU NEED TO REPLACE THE DRIVING SHAFT OR THE SPRING
WITH THE MAINTENANCE
WARNING
: Never raise the arm brackets by means of the crank, without the boom arm fixed for
counterbalancing the spring: the arm brakets would swing violently, with serious injury
risks for the operators.
IMPORTANT INFORMATION CONCERNING HEALTH & SAFETY PROCEDURES
The introduction of a pedestrian or vehicle barrier product as manufactured by Automatic Systems places a
duty of responsibility for the safety and well-being of any user(s) or person(s) in close proximity to such
equipment. You are required therefore to observe and put in place appropriate safety measures, as deemed
necessary.

Pedestrian flow must be prohibited anywhere within a vehicle barrier passage-way, unless the movement of
the barrier system is clearly indicated, e.g. audible and/or visual signals, floor marking, notices, etc.

Access keys to any of the internal mechanisms can only be issued to authorised and qualified personnel,
aware of the relevant electrical and mechanical safety codes and regulations in force.
housing must be kept locked.
You have a legal obligation and responsibility to enforce good safety practices at all times. See also note below.
Note: In the countries of the European Union, the requirement 1.3.7.2 of the EC Machines Directive
prescribes that the pictogram for "Dangerous area* -- no entry for pedestrians" be affixed on both
sides of the equipment (* within 1 meter of the barrier arm in its closed position).
The installation of detection loops must be validated by qualified personnel who will determine their optimal
configuration (adapted to vehicle type and passageway).
WARNING: The risk of injury exists for people when using standard detection loops; they can incorrectly detect
trucks and (motor)bikes and close the gate on them!
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using it for any purpose other than the use of the products or the
execution of the project to which it refers, and from communicating it to third parties without Automatic Systems' prior written agreement. Document subject to change without notice.
BL5x-MT-EN-13
WARNING:
BL52/BL53
COMPRISES A MECHANISM AND VARIOUS ELECTRICAL
NY NEGLIGENCE DURING AN INTERVENTION IN THE MACHINE MAY SERIOUSLY
. A
S SOON AS YOU OPEN THE HOUSING
(1:2). B
.
white
,
SWITCH OFF THE CIRCUIT BREAKER
E CAREFUL IN HANDLING ANY INTERNAL ELEMENT
. T
HE HOOD SHOULD BE REMOVED ONLY
,
ADJUST THE ARM BALANCE OR PROCEED
black
red
All equipment
4/56
page