Copying Required Files To The Standby Sf/Cpu - Nortel 8600 Series Installing

82 Installing Ethernet Routing Switch 8600 modules and connecting equipment
Copying required files to the standby SF/CPU
This procedure is required only if software and configuration files are
different on the Master SF/CPU and the Standby SF/CPU.
Required files can be stored in the following locations:
•
•
•
Step
1
2
Copyright © 2007, Nortel Networks
.
Flash memory: copy files from the Flash memory on the Master SF/CPU
to the flash memory on the Standby SF/CPU
For example: ERS-8606:5# copy/flash/p80axxx.img 127.0.0
6:/flash/p80axxx.img
PCMCIA card: insert a PCMCIA card with the required files, copied
from the Master SF/CPU, into the Standby SF/CPU. Copy files from the
PCMCIA card to the Standby SF/CPU flash memory.
For example: ERS-8606:6# copy/pcm-
cia/p80axxx.img/flash/p80axxx.img
A remote TFTP server: use the TFTP copy command and specify the
destination internal slot IP address for the Standby SF/CPU (127.7.7
<slot>).
For example: ERS-8606:6# copy/<IP address of
server>/path to file/p80axxx.img/flash/p80axxx.img
Action
Copy required files:
The following commands copy all required files from the Flash
memory on the Master CPU to the Flash memory on the Standby
CPU. p80yxxx.img represents the software release. <slot> is either
slot 5 or slot 6, depending on where the Master and Stanby SF/CPU
are installed.
• To copy the runtime image, enter ERS-8606:<slot>#
copy /flash/p80axxxx.img 127.0.0.
<slot>/flash/p80axxxx.img
•
To copy the boot monitor , enter ERS-8606:<slot>#
copy /flash/p80bxxxx.img 127.0.0.
<slot>/flash/p80bxxxx.img
Copy the following files, if required:
Nortel Ethernet Routing Switch 8600
Installing Ethernet Routing Switch 8600 Modules
NN46205-304 01.03 Standard
4.1 2 January 2007
—End—
Nortel Networks Confidential