Nortel 8600 Series Installing page 102

102 Installing Ethernet Routing Switch 8600 modules and connecting equipment
3
4
5
6
7
8
9
Copyright © 2007, Nortel Networks
.
Figure 51
Managing cables: 8010, 8006, 8003 chassis
Route the cable to the termination panel, loosely fastening it with
velcro straps or sheet fiber along the path.
Fasten the connector onto the termination panel end of the cable.
Use the instructions supplied with the connector. If you are using
cables manufactured by Nortel, the connectors are already fastened
to predetermined lengths of cable.
Label the unconnected end of the cable with the node identifier (from
site records) and the shelf, cage, slot, and port number.
When all the transmitting cables from the same module are
connected to the termination panel, use velcro straps or sheet fiber
wrapped around the cables to manage them.
Using a scissors, cut a section of the sheet fiber that is wide enough
to wrap around the cables.
Using a scissors, round the corners of the sheet fiber section.
Loosely wrap the sheet fiber and secure it using lacing cord or tie
wraps (Figure 52 "Wrapping cables with sheet fiber and securing
with lacing cord" (page
Nortel Ethernet Routing Switch 8600
Installing Ethernet Routing Switch 8600 Modules
NN46205-304 01.03 Standard
4.1 2 January 2007
103)).
Nortel Networks Confidential