Replacing A Sf/Cpu Module In A Dual-Sf/Cpu Chassis - Nortel 8600 Series Installing

Replacing a SF/CPU module in a dual-SF/CPU chassis

Before replacing the SF/CPU, you must determine which SF/CPU is operating
as the master SF/CPU. On the Master SF/CPU faceplate, the "Master" LED
blinks green. If you logged onto the switch through Telnet, SSH or through the
console, enter theshow sys info command to determine which SF/CPU is
operating as the master. Enter config sys set action cpuswitchover at
the command prompt of the Master SF/CPU if the SF/CPU you want to replace
is the Master.
To replace a SF/CPU module in a dual-SF/CPU chassis:
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
Replacing a SF/CPU module in a dual-SF/CPU chassis 79
LastRuntimeImageSource :
LastRuntimeConfigSource :
PrimaryImageSource :
PrimaryConfigSource :
SecondaryImageSource :
SecondaryConfigSource :
TertiaryImageSource :
TertiaryConfigSource :
LastRunTimeMezzSource:
Action
Disconnect the cables from the Management and Console ports of
the SF/CPU you want to replace (the current slave), and remove the
SF/CPU module. For more information, see
a module" (page 84).
Insert the new SF/CPU module.
Reconnect the cables.
After the standby SF/CPU boots, verify the software releases
running on new master and new S SF/CPU:
• Log into the master SF/CPU (Telnet/SSH or through the console)
and enter theshow sys sw command.
• Note the software release running on the Master SF/CPU. Verify
that the software release is the same as was previously running
the switch.
Nortel Ethernet Routing Switch 8600
Installing Ethernet Routing Switch 8600 Modules
NN46205-304 01.03 Standard
4.1 2 January 2007
/flash/p80a4100.img
/flash/config.cfg
/flash/p80a4100.img
/flash/config.cfg
/pcmcia/p80a4100.img
/pcmcia/config.cfg
0.0.0.0:
/flash/config.cfg
Not running mezz
—End—
ATTENTION
"Installing and replacing
Nortel Networks Confidential