Nortel 8600 Series Installing page 77

Replacing the CPU
7
8
9
10
11
12
13
14
Copying configuration files to new CPU
15
Copyright © 2007, Nortel Networks
.
Replacing a CPU module in a single-CPU chassis 77
ERS-8606:6# copy /flash/p80c4100.aes
In previous releases, filenames ended with .des rather than .aes.
To copy the R module image if R modules are present:
ERS-8606:6# copy /flash/p80j4100.img /pcmcia/
To copy the SuperMezz image if a SuperMezz daughtercard is
present:
ERS-8606:6# copy flash/p80m4100.dld /pcmcia/
Power down the switch to stop all traffic.
Disconnect the cables from the Management and Console ports.
Remove the old CPU. For additional information about removing
modules, see "Installing and replacing a module" (page 84)
Insert the new CPU. For more information, see
replacing a module" (page
Reconnect the cables to the Management and Console ports, and
insert the pcmcia from the old card.
Connect to the console and open the terminal emulator application.
Power up the switch. Before the system loads the runtime image,
the following message appears: "Loaded boot configuration from
file /flash/boot.cfg Attaching network interface lo0... done. Press
<Return> to stop autoboot..."
Press Return on the keyboard to stop the auto-boot process.
Using the CLI Console port, copy all required files from the PCMCIA
card to the flash memory. For example, enter:
Monitor# copy /pcmcia/boot.cfg /flash/
Monitor# copy /pcmcia/config.cfg /flash/
Monitor# copy /pcmcia/shadov.txt /flash/
Monitor# copy /pcmcia/snmp_usm.txt /flash/
Monitor# copy /pcmcia/snmp_comm.txt /flash/
Monitor# copy /pcmcia/passvord.txt /flash/
Monitor# copy /pcmcia/p80a4100.img /flash/
Monitor# copy /pcmcia/p80b4100.img /flash/
Nortel Ethernet Routing Switch 8600
Installing Ethernet Routing Switch 8600 Modules
NN46205-304 01.03 Standard
4.1 2 January 2007
84).
Nortel Networks Confidential
.
"Installing and