Figure 15. Installing The Phm - Intel M20MYP1UR Integration And Service Manual

Intel® Server System M20MYP1UR System Integration and Service Guide
6. Secure PHM to the processor socket assembly.
• Using a T30 Torx bit screwdriver, securely tighten (12 in-lbs.) each fastener in the sequence shown on
the label located on the top of the heat sink.
Caution: Failure to tighten the heat sink screws in the specified order may cause damage to the processor
socket assembly. Each heat sink screw should be fully tightened to 12 in-lbs. torque before securing the next
screw in the sequence.
7. For a second procesor, repeat the processor installation instructions above, ensuring the proper
processor heatsink and processor carrier clip are used for the installation.
For single processor configurations where a 2
CPU 2 socket without removing the processor socket cover to ensure proper airflow when the system is
operational.

Figure 15. Installing the PHM

nd processor is not present, install the CPU 2 heat sink onto the
23