Installing Two M.2 Devices (Dual Configuration); Figure 45. Installing Two M.2 Ssd Devices (Dual Configuration) - Intel M20MYP1UR Integration And Service Manual

Intel® Server System M20MYP1UR System Integration and Service Guide
3.6.2

Installing Two M.2 Devices (Dual Configuration)

1. Power off the system and disconnect the AC power cord.
2. Remove the system top cover (see Section 2.1.1).
3. Locate the M.2 connectors on the server board near the DIMM slots.
4. Remove the bracket using a Phillips* (cross head) screwdriver.
5. Attach the bracket to the M.2 device that will be installed on the top connector using the provided screw
(see Letter A).
6. Slide the M.2 device that is to be installed on the bottom connector first and then the device to be
installed on the top connector (see Letter B).
7. Secure the M.2 devices to the server board with the provided screw (see Letter C).
Caution: Ensure the M.2 SSDs are properly aligned with the server board notch and the bracket before
tightening them. Mis-alignment may cause damage to the M.2 SSD or the server board when tightening.

Figure 45. Installing two M.2 SSD devices (dual configuration)

43