Figure 34. Installing The Phm - Intel R1000WF System Integration And Service Manual

Intel ® Server System R1000WF Product Family System Integration and Service Guide
4. Secure PHM to the processor socket assembly

Using a T30 Torx bit screwdriver, securely tighten (12 in-lb) each fastener in the sequence shown on
the label located on the top of the heat sink
CAUTION: Failure to tighten the heat sink screws in the specified order may cause damage to the processor
socket assembly. Each heat sink screw should be fully tightened to 12 in-lb torque before securing the next
screw in the sequence.
5. For a second procesor, repeat the processor installation instructions above, ensuring the proper
processor heatsink and processor carrier clip are used for the installation.
For single processor configurations where a 2
CPU #2 socket to ensure proper air flow when the system is operational.
See section 3.10 for installation instructions related to fabric processor accessory kits.
22

Figure 34. Installing the PHM

nd processor is not configured, install the CPU#2 heat on to the