Software Requirement For Sm-Xs; Locate Sm-X Or Nim; Remove Sm-X Or Nim; Install Sm-X - Cisco 4000 Series Hardware Installation Manual

Chapter 5 Install and Upgrade Internal Modules and FRUs

Software Requirement for SM-Xs

Cisco IOS XE software of a specified release or later release is required for using an SM-X.
To determine the version of Cisco IOS software that is running on your router, log in to the router and
enter the show version command:
Router> show version
Cisco Internetwork Operating System Software
4400 Software (C4400-ADVENTERPRISEK9-M), Version 12.3(8.2)T, INTERIM SOFTWARE

Locate SM-X or NIM

See the
motherboard.

Remove SM-X or NIM

To remove an SM-X:
Read the
Step 1
module.
Access the SM-X slot. See
Step 2
Loosen the captive screws to open the slot cover. See
Step 3
Pull the SM-X out of the connector on the motherboard. Keep the SM-X parallel with the motherboard
Step 4
to prevent damage to the slot and standoff.
Place the SM-X in an antistatic bag to protect it from ESD damage.
Step 5

Install SM-X

To install an SM-X, use a number 2 Phillips screwdriver or flat-blade screw drive, and a 1/4-inch nut
driver or wrench.
Read the
Step 1
module.
To inset the SM-X, identify the SM-X slot.
Step 2
Loosen the captive screws to open the slot cover. See
Step 3
Insert the SM-X to the system board.
Step 4
Note
Insert the screws from the accessory kit through the SM-X into the standoffs. See
Step 5
the screws with a Phillips screwdriver (torque 6 to 8 in-lb or 0.7 to 1.1 Nm.).
OL-32185-02
"Locate Internal and External Slots" section on page 5-6
"Safety Warnings" section on page 5-2
Figure 5-4
"Safety Warnings" section on page 5-2
Press firmly on the SM-X until the board is properly installed on the connector.
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Install and Remove NIMs and SM-Xs on Cisco 4000 Series ISRs
and disconnect the power supply before you replace any
for the various NIM and SM-X slot locations.
Figure 5-12
and disconnect the power supply before you replace any
Figure 5-12
to locate the SM-X or NIM slot on the
and Figure 5-13.
and Figure 5-13.
Figure 5-29. Tighten
5-31