Cisco Ios Software Basics - Cisco WS-X3011 Configuration Note

Access the Router Card Command-Line Interface
Figure 11
The options on the menu are as follows:
•
•
•
•
•
•
•
•

Cisco IOS Software Basics

This section provides you with some basic information about the Cisco IOS software, and includes
the following topics:
•
26 Router Card (WS-X3011) Configuration Note
Router Configuration Menu
Use cursor keys to choose item. Press <RETURN> to confirm choice.
Press <CTRL><P> to return to Main Menu.
Boot Up Console Select – Displays two boot-up choices: switch and router. You can set the
default boot-up console to be either the switch Main Menu or the router command-line interface.
Switch to Router Console – Provides access to the router command line interface. This option
functions the same as pressing ^R. To return to the switch menus from the router command line
interface, press ^R.
Router Reset – Resets the router card without resetting the switch.
Board Info – Displays information about the board.
Net Addr – Displays the IP address of the Ethernet port (e0) that connects the router card to the
switch.
Op State – Displays the operational state of the router card.
Router Boot Option – Displays two choices for the default bootup procedure: With Switch, and
Leave Alone. Selecting With Switch forces the router card to reboot whenever the switch is
rebooted. Selecting Leave Alone sets the router card to remain running whenever the switch is
rebooted.
Router Flow Control – Displays two choices: None, and Software Flow Control. The default is
None. If characters are not diplayed correctly on the router CLI, change the router flow control
to software flow control.
Cisco IOS Modes of Operation
Router Configuration
Return to Previous Menu
Boot Up Console Select
Switch to Router Console
Router Reset
0x22 0x0
Board Info
10.10.10.1
Net Addr
Up
Op State
Router Boot Option
Router Flow Control
Return to Previous Menu