Cisco 4000 Series Hardware Installation Manual page 174

Remove and Replace Cisco 4000 Series ISRs Power Supplies
Figure 5-39
2
1 Bezel
Insert the wires through the holes in the bezel. Replace the bezel.
Step 6
Insert the exposed wire into the terminal block. Ensure that the wire lead is not placed outside the plastic
Step 7
cover. Only wires with insulation should extend from the terminal block.
Do not overtorque the terminal block captive screws. Ensure that the connection is snug, but the wire is
Caution
not crushed. Verify by tugging lightly on each wire to ensure that they do not move.
Use a screwdriver to tighten the terminal block captive screws, as shown in
Step 8
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-50
Remove the Bezel
1
Chapter 5 Install and Upgrade Internal Modules and FRUs
2
2 DC power supplies
Figure 5-40.
OL-32185-02