Remove Ssd Drives From The Nim-Ssd - Cisco 4000 Series Hardware Installation Manual

Overview of the SSD Carrier Card NIM (NIM-SSD)
Figure 5-13
1
Insert an SSD in the lower slot first.
Step 3
Insert the SSD connector end first with the connector side down and serial number facing up
Step 4
(Figure
A second SSD may be inserted in the upper slot as shown in
Step 5
Rotate the SSD card slot cover up and place it over the SSDs.
Step 6
Tighten the captive fasteners on the SSD card slot cover.
Step 7

Remove SSD Drives from the NIM-SSD

Prior to removing the NIM-SSD card, power off the device using
Note
stop command in EXEC mode.
To remove the SSD cards from the NIM carrier:
On the NIM-SSD, loosen the captive screws retaining the NIM-SSD slot cover.
Step 1
Rotate the SSD card slot cover down, exposing the slots that hold the SSDs.
Step 2
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-18
Opening the SSD Slot Cover
Carrier card slot cover
5-10).
Chapter 5 Install and Upgrade Internal Modules and FRUs
1
Figure 5-11.
t
he hw-module subslot slot / subslot
OL-32185-02