Overview; Remove And Replace Cisco Nim-Ssd Or Nim-Hdd; Install And Remove Ddr Dimms On Cisco 4400 Or 4300 Series Isrs - Cisco 4000 Series Hardware Installation Manual

Overview of the SSD Carrier Card NIM (NIM-SSD)
•
•
•
•
•

Overview

The solid state drive (SSD) carrier card network interface module (NIM) enables SSD support on the
platform NIM slots. It provides flash storage to the platform and supports dual 2.5" (7mm max) SATA
SSDs. The carrier card fits into the NIM slots in the router. The router supports only a single SSD Carrier
Card NIM.
Refer to the "Network Interface Modules" section of the
Note
Series ISRs
The SSD carrier card NIM
•
•
•
•
•
•
•
Figure 5-7
Figure 5-7
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-12
Solid State Drives
Install SSD Drives into the NIM Carrier Card
Remove SSD Drives from the NIM-SSD

Remove and Replace Cisco NIM-SSD or NIM-HDD

Install and Remove DDR DIMMs on Cisco 4400 or 4300 Series ISRs

for configuration information on the SSD carrier card NIM.
(Figure
Single-wide NIM form factor
LEDs for module and driver status
On board PCIe x1 Gen 2(5G) dual-port SATA controller
SFF 2.5" SATA2 or SATA3 (7mm or less) SSDs Support
Supports module online insertion and removal (OIR): You can remove it from a bay and insert it into
a bay while the router is running
NIM-SSD support in any bay in slot 0
Support for only one NIM-SSD module per router
shows the front panel of the SSD NIM.
Front Panel of the SSD Carrier Card NIM
Chapter 5
Software Configuration Guide for Cisco 4000
5-7) has the following features:
Install and Upgrade Internal Modules and FRUs
OL-32185-02