Software Requirement For Sm-Xs; Locate Sm-X Or Nim; Remove Sm-X Or Nim; Install Sm-X - Cisco 4451 ISR Hardware Installation Manual

Install and Remove NIMs and SM-Xs on Cisco 4000 Series ISRs
Caution
Handle SM-Xs and NIMs by the edges only. SM-Xs are ESD-sensitive components and can be damaged
by mishandling.

Software Requirement for SM-Xs

Cisco IOS XE software of a specified release or later release is required for using an SM-X.
To determine the version of Cisco IOS software that is running on your router, log in to the router and
enter the show version command:
Router> show version
Cisco Internetwork Operating System Software
4400 Software (C4400-ADVENTERPRISEK9-M), Version 12.3(8.2)T, INTERIM SOFTWARE

Locate SM-X or NIM

See the
motherboard.

Remove SM-X or NIM

To remove an SM-X:
Step 1
Read the
module.
Step 2
Access the SM-X slot. See
Step 3
Loosen the captive screws to open the slot cover. See
Step 4
Pull the SM-X out of the connector on the motherboard. Keep the SM-X parallel with the motherboard
to prevent damage to the slot and standoff.
Step 5
Place the SM-X in an antistatic bag to protect it from ESD damage.

Install SM-X

To install an SM-X, use a number 2 Phillips screwdriver or flat-blade screw drive, and a 1/4-inch nut
driver or wrench.
Step 1
Read the
module.
Step 2
To inset the SM-X, identify the SM-X slot.
Step 3
Loosen the captive screws to open the slot cover. See
Step 4
Insert the SM-X to the system board.
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
6-30
"Locate Internal and External Slots" section on page 6-6
"Safety Warnings" section on page 6-2
Figure 6-2
"Safety Warnings" section on page 6-2
Chapter 6 Install and Upgrade Internal Modules and FRUs
and disconnect the power supply before you replace any
for the various NIM and SM-X slot locations.
Figure 6-10
and disconnect the power supply before you replace any
Figure 6-10
to locate the SM-X or NIM slot on the
and Figure 6-11.
and Figure 6-11.
OL-32185-02