Install The Pvdm4 On The Motherboard Of Cisco 4331 Isr - Cisco 4000 Series Hardware Installation Manual

Install and Remove PVDM4 on Cisco 4400 or 4300 Series ISRs

Install the PVDM4 on the Motherboard of Cisco 4331 ISR

Read the
Step 1
module.
Turn off electrical power to the router. Leave the power cable plugged in to channel ESD voltages to
Step 2
ground.
Step 3 Remove the cover.
Identify the ISC slot on the router's main motherboard.
Step 4
Locate the three standoffs from the motherboard. See
Step 5
Insert the PVDM4 into the ISC slot on the system board.
Step 6
Note
Insert the screws from the accessory kit through the PVDM4 into the standoffs. Tighten the screws with
Step 7
a Phillips screwdriver (torque 6 to 8 in-lb. or 0.7 to 1.1 Nm).
Check that the PVDM4 is installed correctly on the system board.
Step 8
Replace the cover.
Step 9
When you remove or install the PVDM4, always wear an ESD-preventive wrist strap, and ensure that it
Caution
makes good contact with your skin. Connect the equipment end of the wrist strap to the metal part of the
chassis.
Handle the PVDM4 by the edges only. PVDM4s are ESD-sensitive components and can be damaged by
Caution
mishandling.
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Only trained and qualified personnel should be allowed to install, replace, or service
Warning
this equipment. Statement 1030
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-36
"Safety Warnings" section on page 5-2
Press firmly on the PVDM4 until the board seats onto the connector.
Chapter 5 Install and Upgrade Internal Modules and FRUs
and disconnect the power supply before you replace any
Figure 5-28.
OL-32185-02