Remove The Flash Memory Card; Install And Remove An Ssd Msata Storage Device; Prevent Electrostatic Discharge Damage - Cisco 4000 Series Hardware Installation Manual

Install and Remove an SSD mSATA Storage Device

Remove the Flash Memory Card

Read the
Step 1
any module.
Remove the chassis cover. For instructions on removing the chassis cover, see
Step 2
Chassis Cover" section on page
Step 3 Unscrew the flash memory card, see
Install a new flash memory card if needed. See
Step 4
Replace the chassis cover. See
Step 5
Install and Remove an SSD mSATA Storage Device
This section describes installing and replacing an SSD mSATA storage device in Cisco 4300 ISR routers.
•
•
•

Prevent Electrostatic Discharge Damage

The SSD mSATA storage devices are sensitive to electrostatic discharge (ESD) damage, which can occur
when electronic cards or components are handled improperly. ESD results in complete or intermittent
failures.
To prevent ESD damage, follow these guidelines:
•
•
•
•
•
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
Caution
between 1 and 10 megohms (Mohms).
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-72
"Safety Warnings" section on page
Prevent Electrostatic Discharge Damage, page 5-67
Install the SSD mSATA Storage Device, page 5-73
Remove the SSD mSATA Storage Device, page 5-74
Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Connect the equipment end of the strap to an unfinished chassis surface.
Place the SSD mSATA storage devices on an antistatic surface or in a static shielding bag. If the
device is to be returned to the factory, immediately place it in a static shielding bag.
Avoid contact between the device and clothing. The wrist strap protects the device from ESD
voltages on only the body; ESD voltages on clothing can still cause damage.
Do not remove the wrist strap until the installation is complete.
Chapter 5
5-2, and disconnect the power supply before you replace
5-4.
Figure 5-54.
Install the Flash Memory Card, page
"Remove and Replace Chassis Cover" section on page
Install and Upgrade Internal Modules and FRUs
"Remove and Replace
5-70.
5-4.
OL-32185-02