Install The Flash Memory Card - Cisco 4000 Series Hardware Installation Manual

Remove and Install the Flash Memory Card
•
•
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
Caution
between 1 and 10 megohms (Mohms).

Install the Flash Memory Card

Read the
Step 1
module.
Remove the chassis cover. For instructions on removing the chassis cover, see
Step 2
Chassis Cover" section on page
Place the flash memory card on top of the flash memory card connector (see
Step 3
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
5-70
Avoid contact between the card and clothing. The wrist strap protects the card from ESD voltages
on only the body; ESD voltages on clothing can still cause damage.
Do not remove the wrist strap until the installation is complete.
"Safety Warnings" section on page 5-2
Chapter 5
and disconnect the power supply before you replace any
5-4.
Install and Upgrade Internal Modules and FRUs
"Remove and Replace
Figure 5-54).
OL-32185-02