Attach Chassis To Wall Or Mount Chassis In Rack; Install Cisco 4400 Or 4300 Isr; Install Cisco 4200 Series Isr - Cisco 4000 Series Hardware Installation Manual

Chapter 3 Install and Connect Cisco 4000 Series ISRs
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
Warning
handles on modules (such as power supplies, fans, or cards); these types of handles are not designed
to support the weight of the unit. Statement 1032.
Caution Do not place anything on top of the router that weighs more than 10 pounds (4.5 kg), and do not stack
routers on a desktop. Excessive distributed weight of more than 10 pounds, or pound point load of
10 pounds on top could damage the chassis.
Your chassis installation must allow unrestricted airflow for chassis cooling. For placing the router on a
Caution
desktop, keep at least 1 inch (2.54 cm) of clear space beside the cooling inlet and exhaust vents.
After the router is installed, you must connect the chassis to a reliable earth ground. For the chassis
ground connection procedures, see the

Attach Chassis to Wall or Mount Chassis in Rack

The tasks that you perform for attaching the router chassis to the wall, or for mounting it in a rack, are
based on the specific model of the Cisco 4000 Series Integrated Service Router.
See the relevant installation sub-section for your specific router in the Cisco 4000 Series ISRs:
•
•

Install Cisco 4400 or 4300 ISR

This section describes the installation procedure that is common for all Cisco 4400 and 4300 Series ISRs.
For illustration purposes, we have used images of Cisco 4400 Series ISRs in all figures.
Note
Attach Cisco 4400 or 4300 ISR Chassis to Wall
Attach the wall-mounting brackets to the router chassis as shown in
Step 1
screws and the plastic spacers provided for each bracket.
OL-32185-02
Install Cisco 4400 or 4300 ISR

Install Cisco 4200 Series ISR

Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
"Chassis Grounding" section on page
Install the Router
3-19.
Figure 3-1 using the four PHMS
3-5