Chapter 5
Install and Upgrade Internal Modules and FRUs
Remove PoE Converter Power Supply
Remove the bezel and fan try from the router chassis.
Step 1
Open the slot latch. See
Remove the PoE converter power supply module.
Step 2
Replace PoE converter power supply filler. See
Step 3
details.
After you remove the PoE converter PSU, you need to either install a replacement power or put the filler.
Install the PoE Power Supply Slot Filler
You cannot keep the slot empty, you need to install the filler.
Remove the bezel and fan tray from the router.
Step 1
Insert the filler tab into the slot on the chassis.
Step 2
Tighten the screws into the securing nuts on the chassis. See
Step 3
OL-32185-02
Figure 5-47
for details.
"Remove PoE Power Supply Slot Filler"
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
PoE Converter Power Supply Unit
Figure 5-46
for details.
section for
5-59