Snmp Agent - ProSoft Technology RLX2-IHx Series User Manual

RLX2-IHx Series ♦ 802.11a, b, g, n
Industrial Hotspots

4.6.4 SNMP Agent

You use the parameters in the SNMP A
Network Management Protocol parameters of your RLX2-IHx series radio.
SNMP is a network management protocol that is often used with TCP/IP and
Ethernet. It offers an alternative to using the radio web interface, and allows you
to use an SNMP manager application to change radio settings and view
diagnostics.
Parameter
Enable
Allow Any Manager
Allow IP
Community String
Permission

The RLX2-IHx series radio's SNMP agent supports SNMP protocol version
1.4 and 2.

MIBs:
o RFC12133-MIB (partial; internet.mgmt.MIB-2.system, .interfaces, .snmp)
o ROMAP-MIB (internet.private.enterprises.romap)

It also supports a selection of standard SNMP traps, including Cold Start,
which the radio sends when it initializes.
ProSoft Technology, Inc.
GENT
Description
Select this check box to enable the following SNMP agent.
Specifies that any user can change the radio configuration from any
computer using SNMP.
Specifies that only an SNMP manager with a particular IP address can
change the radio configuration. You must enter the IP address.
Specifies a community string (similar to a password) that an SNTP
manager must use to access the radio's SNMP agent.
Specifies the permission level to assign to this radio.
R O - The SNMP manager can view, but cannot change the radio
EAD NLY
configuration.
R /W - The SNMP manager can view and make changes to the
EAD RITE
radio configuration.
Configuring a Radio - Detailed Configuration
group to specify the Simple
User Manual
Page 105 of 250