Grandstream Networks GSC3570 User Manual page 55

Voice Frames Per TX
G723 Rate
iLBC Frame Size
iLBC Payload Type
OPUS Payload Type
DTMF Payload Type
Send DTMF
DTMF Delay
Video Settings
H.264 Image Size
Configures the number of voice frames transmitted per packet. When
configuring this, it should be noted that the "ptime" value for the SDP will
change with different configurations here. This value is related to the codec
used and the actual frames transmitted during the in-payload call. For end
users, it is recommended to use the default setting, as incorrect settings may
influence the audio quality. The default setting is 2.
This option determines the encoding rate for G723 codec. Users can choose
from 6.3kbps encoding rate and 5.3kbps encoding rate.
The default setting is "5.3kbps encoding rate".
This option determines the iLBC packet frame size. Users can choose from
20ms and 30ms. The default setting is "30ms".
This option is used to specify iLBC payload type. Valid range is 96 to 127.
The default setting is "97".
Specifies OPUS payload type. Valid range is 96 to 127. Cannot be the same
as iLBC or DTMF Payload Type. Default value is 123.
Configures the payload type for DTMF using RFC2833. Cannot be the same
as iLBC or OPUS payload type.
This parameter specifies the mechanism to transmit DTMF digits.
There are 3 supported modes:
• In audio: DTMF is combined in the audio signal (not reliable with low-bit-
rate codecs).
• RFC2833 sends DTMF with RTP packet. Users can check the RTP packet
to see the DTMFs sent as well as the number pressed.
• SIP INFO uses SIP INFO to carry DTMF.
Default setting is "RFC2833".
Configures the delay between sending DTMF (in milliseconds). Default is
250 ms.
Sets the H.264 image size. It can be selected from the dropdown list.
•
720P
•
4CIF
•
VGA
•
CIF
•
QVGA
GSC3570 User Manual
Version 1.0.3.1
P a g e | 54