Table of Contents
Advertisement
Firmware Version
To view the current firmware version of the Vivid Drive 28N:
1. Access the
Advanced Settings
2. Turn the <MENU> knob until HW Version is selected.
3. Press the <MENU> knob.
Factory Reset
To reset the Vivid Drive 28N to factory default settings:
1. Press the <MENU> knob to access the menu.
2. Turn the <MENU> knob until Factory Reset is selected.
3. Press the <MENU> knob.
Communication Settings
The Communication Settings include the communication method preference and the network settings such
as the IP address. To access the Communication Settings menu:
1. Press the <MENU> knob to access the menu.
2. Turn the <MENU> knob until Communication Settings is selected.
3. Press the <MENU> knob.
Communication Mode
The Communication Mode setting determines which connection will take priority if both the USB and RJ45
ports are connected.
1. Access the
Communication Settings
2. Turn the <MENU> knob until Communication Mode is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob clockwise or counterclockwise to select from USB Preferred or LAN
Preferred.
5. Press the <MENU> knob.
Network Settings
The Network Settings include the IP Address and the Subnet Mask. To access the Network Settings menu:
1. Access the
Communication Settings
2. Turn the <MENU> knob until Network Settings is selected.
3. Press the <MENU> knob.
IP Configuration
To change between a default IP address and setting one manually:
1. Access the
Network Settings
2. Turn the <MENU> knob until Config IPV4 is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob clockwise or counterclockwise to select Manually (uses a custom IP
address) or Auto (uses a default IP address).
5. Press the <MENU> knob.
Custom IP Address
To set a custom IP address:
1. Access the
Network Settings
2. Set Config IPV4 to Manually.
3. From the Network Settings menu, turn the <MENU> knob until IP Address is selected.
4. Press the <MENU> knob.
5. Turn the <MENU> knob clockwise or counterclockwise to increase or decrease the first number
value in the IP address, from 1–223.
6. Press the <MENU> knob.
7. Turn the <MENU> knob clockwise or counterclockwise to increase or decrease the second
number value in the IP address, from 0–255.
8. Press the <MENU> knob.
9. Repeat steps 7 and 8 for the third and fourth number values in the IP address.
10. If necessary, repeat steps 5-9 until the IP address is set as desired.
11. Press <ESC> to return to the previous menu level.
Page 31 of 37
menu.
menu.
menu.
menu.
menu.
Operation
Vivid Drive 28N User Manual Rev. 1
Advertisement
Table of Contents
