Table of Contents
Advertisement
Operation
Custom Output Resolution
To set a Custom Resolution, follow the instructions below.
1. Set the width.
a. Access the
Output Resolution
b. Turn the <MENU> knob until Custom Resolution is selected.
c. Press the <MENU> knob.
d. Turn the <MENU> knob until Width (H) is selected.
e. Press the <MENU> knob.
f.
Turn the <MENU> knob clockwise or counterclockwise to increase or decrease the width, from
800–3840.
g. Press the <MENU> knob.
2. Set the height.
a. From having set the width, turn the <MENU> knob until Height (V) is selected.
b. Press the <MENU> knob.
c. Turn the <MENU> knob clockwise or counterclockwise to increase or decrease the height,
from 600–1920.
a. Press the <MENU> knob.
3. Set the refresh rate.
a. From having set the height, turn the <MENU> knob until Custom Refresh Rate is selected.
b. Press the <MENU> knob.
c. Turn the <MENU> knob clockwise or counterclockwise to increase or decrease the refresh
rate, from 24–60Hz.
d. Press the <MENU> knob.
4. Apply the changes.
a. From having set the refresh rate, turn the <MENU> knob until Apply is selected.
b. Press the <MENU> knob to save the custom output resolution and apply it.
Cabinet Settings
The Cabinet Settings allow the firmware of the connected panels to be updated through the
Vivid Drive 28N, temporarily or permanently. To access the Cabinet Settings menu:
1. Access the
Advanced Settings
2. Turn the <MENU> knob until Cabinet Settings is selected.
3. Press the <MENU> knob.
Temporary Panel Firmware Update
Using this setting will send a selected pre-loaded file to the connected panels. The connected panels will
return to their previous setting upon cycling their power.
1. Access the
Cabinet Settings
2. Turn the <MENU> knob until Load RCFG Files is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob clockwise or counterclockwise to select which file to send to the
connected panels.
5. Press the <MENU> knob.
Permanent Panel Firmware Update
To permanently save the temporarily loaded firmware update to the connected panels:
1. From the
Cabinet Settings
2. Turn the <MENU> knob until Save to RV Card is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob clockwise or counterclockwise to select No (do not save permanently) or
Yes (save permanently).
1. Press the <MENU> knob.
Display Brightness
To change the brightness of the OLED display on the Vivid Drive 28N:
1. Access the
Advanced Settings
2. Turn the <MENU> knob until OLED Brightness is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob clockwise or counterclockwise to increase or decrease the brightness,
from 6–15.
5. Press the <MENU> knob.
Vivid Drive 28N User Manual Rev. 1
menu.
menu.
menu.
menu.
menu.
Page 30 of 37
Advertisement
Table of Contents
