Data Flow - Chauvet DJ Vivid Drive 28N User Manual

Operation

Data Flow

This setting addresses the panels in the connected assembly for both ports by selecting a starting point
and a direction of flow, as seen from the front of the assembly.
1. Access the Screen Settings
2. Turn the <MENU> knob until Data Flow(Front View) is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob clockwise or counter-clockwise to select from the following options:
5. Press the <MENU> knob.
The number of panels connected to port 2 may only be equal to or less than the number
set to port 1.
For example: If there are 5 rows and 10 columns (50 total panels), port 1 can be set from
25–30. If port 1 is set to 30, port 2 will output to 20 panels (30+20 = 50). If port 1 is set to 25,
both ports will output to 25 panels (25+25 = 50).
Port 1 will not be able to be set to any number lower than 25 because that is the lowest
number that will allow port 2 to be equal to or less than port 1.
These numbers assume the default settings are available, and not overridden by the
firmware of connected panels.
Vivid Drive 28N User Manual Rev. 1
menu.
Icon Meaning
Starts at top left, goes all the way right, down by
one, all the way left, down by one, and repeats.
Starts at top left, goes all the way down, right by
one, all the way up, right by one, and repeats.
Starts at top right, goes all the way left, down by
one, all the way right, down by one, and repeats.
Starts at top right, goes all the way down, left by
one, all the way up, left by one, and repeats.
Starts at bottom left, goes all the way right, up by
one, all the way left, up by one, and repeats.
Starts at bottom left, goes all the way up, right by
one, all the way down, right by one, and repeats.
Starts at bottom right, goes all the way left, up by
one, all the way right, up by one, and repeats.
Starts at bottom right, goes all the way up, left by
one, all the way down, left by one, and repeats.
Page 18 of 37