Picture In Picture - Chauvet DJ Vivid Drive 28N User Manual

Operation

Picture In Picture

The Picture In Picture function allows 2 video sources to be displayed at once on the same video panel
assembly from a single Vivid Drive 28N. To access the Picture In Picture menu:
1. Access the Advanced Settings
2. Turn the <MENU> knob until PIP is selected.
3. Press the <MENU> knob.
To enable PIP, press <TAKE>. To enable or disable PIP through the menu:
1. Access the Picture In Picture
2. Turn the <MENU> knob until PIP is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob to select Disable or Enable.
5. Press the <MENU> knob.
Picture In Picture Layout
This setting determines the location upon the connected panel assembly where the Picture In Picture video
will appear.
1. Access the Picture In Picture
2. Turn the <MENU> knob until LAYOUT is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob to select the layout, from CUSTOM (layout is set independently),
L+T (left and top), L+B (left and bottom), R+T (right and top), R+B (right and bottom),
CENT (center), or T+B (top and bottom).
5. Press the <MENU> knob.
Main Source
To set the Main Input Source
1. Access the Picture In Picture
2. Turn the <MENU> knob until Main Source is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob to select the Main Input Source, from HDMI, DVI, VGA2, VGA3, CVBS1,
CVBS2, DP, or VGA1.
5. Press the <MENU> knob.
Picture In Picture Source
To set the video source for the Picture In Picture function:
1. Access the Picture In Picture
2. Turn the <MENU> knob until PIP Source is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob to select the PIP Input Source, from HDMI, DVI, VGA2, VGA3, CVBS1,
CVBS2, DP, or VGA1.
5. Press the <MENU> knob.
The PIP Input Source and Main Input Source cannot both be set to either digital or analog
video inputs. One must be digital (HDMI, DVI, or DP), and the other must be analog (VGA or
CVBS).
Picture In Picture Width
To set the width of the space allocated for the Picture In Picture on the connected panel assembly:
1. Access the Picture In Picture
2. Turn the <MENU> knob until Width (H) is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob clockwise or counterclockwise to increase or decrease the width, from
64–_ _ _ _ (This range is determined by the
5. Press the <MENU> knob.
Picture In Picture Height
To set the height of the space allocated for the Picture In Picture on the connected panel assembly:
1. Access the Picture In Picture
2. Turn the <MENU> knob until Height (V) is selected.
3. Press the <MENU> knob.
4. Turn the <MENU> knob clockwise or counterclockwise to increase or decrease the height, from
64–_ _ _ _ (This range is determined by the
5. Press the <MENU> knob.
Vivid Drive 28N User Manual Rev. 1
menu.
menu.
menu and enable the function.
through the menu:
menu.
menu.
menu and enable the function.
Input
menu and enable the function.
Input
Settings).
Settings).
Page 24 of 37