Maintenance And Replacement Parts - Hunter TCX56 Operating Instructions Manual

Maintenance Schedule
Periodically

4.2 Maintenance and Replacement Parts

Safety Goggles
Brush
Mounting Paste
Polymer Mount/Demount Head
Hand Held Bead Lever - straight
Bead Lever Protector Sleeve (Std) (4)
Jaw Protection Kit (2 sets - 8 covers)
TCX56
Steel Head Inserts (10 sets - 20 covers)
TCX57
Mount/demount Protector Kit consisting of:
10 demounting protectors
5 mounting protectors
15 protector screws
62
Daily
Weekly
NAME
Perform the Following Maintenance
Drain condensation from pressure regulator
reservoir by pressing in on the fitting located on
the bottom of the regulator.
Check for worn or damaged rubber and nylon
components that should be replaced to prevent
damage from occurring. Replace worn parts
as needed (tool supports, rubber pads, lever
protector sleeve and mount/demount head).
Clean all areas that contact rims or tires to
preventpossible scratching to rim.
Clean tire changer with shop towels or a vacuum
cleaner. Do not clean with or use compressed
air, which can blast dirt between moving parts.
Do not use cleaning solvents to clean pressure
regulator/oiler.
Refill the pressure regulator/oiler using only
Hunter Lubri-Oil, 148-133-2, as needed.
Petroleum-based oils should never be used in
the oiler and may void all warranties.
Adjust the oiler to release one drop of oil every
three rotations of the clamping table by adjusting
the screw on top.
Check for loose bolts and tighten per
specifications.
NUMBER
179-15-2
RP6-1506
RP6-3784
RP11-3314813
RP11-3009516
RP11-8-11400098
RP11-8-11400085
RP11-8-11400096
RP11-8-11400293
Operation Instructions for TCX56/57 Tire Charger