Hunter TCX56 Operating Instructions Manual page 59

3. If the gap is not correct, release the head position lock and adjust the nuts beneath
the horizontal post locking system cover to adjust the gap. The cover must be
removed. Back off the nuts to increase the gap and tighten to reduce the gap.
To ensure that the horizontal locking plate functions correctly, the two nuts must be
adjusted symmetrically.
4. Reposition the tool head on the rim and lock it in place with the head position lock.
Re-check gap.
5. When the adjustments are complete, check the gap between the hook of the tool head
and the outboard safety hump of the rim. The distance should be between .08 and .16
inch. If not, repeat the calibration process.
6. When finish mount the cover.
Operation Instructions for TCX56/57 Tire Charger
REMOVE THE
HORIZONTAL POST
LOCKING SYSTEM
COVER
NOTICE
ADJUSTMENT
NUT
.08 - .16
inch GAP
59