Removal Of Wheel From Tire Changer - Hunter TCX56 Operating Instructions Manual

Step down partially on the pedal to inflate tire and seal beads with inflation hose. Frequently
stop to check bead seating pressure on gauge.
Do not exceed tire manufacturer's maximum pressure as stated on the sidewall of
the tire when seating beads.
Reinstall valve stem core into the valve stem after beads have been seated, and then inflate
tire to vehicle manufacturer recommended pressure.
Activate air inflation jets only when sealing bead.
Bleed air pressure from system before disconnecting supply line or other pneumatic
components. Air is stored in a reservoir for operation of inflation jets.
Only activate the air inflation jets if the rim securing device is locked in place and the
tire is properly clamped.
Never mount a tire to a rim that is not the same diameter (e.g., 16 1/2 inch tire
mounting on a 16 inch rim).
If tire is over-inflated, air may be removed from the tire by pressing the brass manual air
release button located below the air pressure gauge.
Disconnect inflation hose from valve stem.

2.9 Removal of Wheel from Tire Changer

Lift the clamping pedal
48
WARNING
WARNING
WARNING
WARNING
to release the rim from the clamping device.
Operation Instructions for TCX56/57 Tire Charger